· We bought a used FCA to use as a backup for our ioline. I have been given a Graphtec fca which was just sitting around. /buffering etc. other then it saying that i have no idea how to check if its HP-GL or GP-GL. i have been able to find a FC manual where it talks about the dip switches however on the model i have i. · Mark Pack. Member. Septem at pm. Hi everyone. I have just bought a new LCD for my cutter. The first one I got didn’t work, and the exchange I now have reads either Chinese or Japanese. I don’t know what it read before I bought it because the screen was already cracked. Page 42 FC Service Manual P/NT Rev. A (4) As shown in Fig, remove the 60A FPC cable holder. • Two M2 x L4 bind-head screws Fig. (5) As shown in Fig, disconnect the pen block FPC cable from the PR pen board's J32 connector. Page Replacing And Adjusting The Y Slider Belt.
GRAPHTEC CUTTING PRO FCA DRIVER - I am new to all of this and am looking to get started in vinyl cutting. Speed is a matter of preference. Great machine, works great, would buy another one. Graphtec does not support software/driver used with operating systems that have become obsolete and are no longer supported by the OS developer. (*3) In plug-in software Cutting Master 2 and Cutting Master 3, new version will not be released even if the OS or application software is updated. Graphtec ce vinyl cutter, contour cutting with a mac - duration,.the specifications and other information in this manual are subject to change to ensure safe and correct use of your plotter, read this manual www.doorway.ruec fc vinyl cutter setup instructions using a usb connection you may have to install the graphtec windows.
Hello, Hoping you can offer me advice. I have a Graphtec CuttingProFC 60A plotter that uses a parallel connector (DB25, I believe, I will attach a photo of the cable I’m using). Since OS came out, my adaptor no longer works and there is no hope for a new driver from Tripplite (who. GRAPHTEC AMERICA, INC, Armstrong Avenue, Irvine, CA, , United States () I am new to all of this and am looking to get started in vinyl cutting. I am currently looking at a used Graphtec FCA and am wondering if anyone else has used this cutter and could give me some ideas of it's performance and specifications. I can't seem to find any detailed info on the.
0コメント